Assembly Instructions Caution: You must read this before you proceed Coffee Table Part List Label Picture Description QTY A Leg 4 B Connecting Rod 1 C Metal Ring 1 Page 1 OF 8
D Clear Glass 1 Description QTY ① Bolt (M6*12mm) 21 ② Allen Key 1 ③ Anti-skid Pad 5 Hardware Label Picture Assembly Preparation Before Beginning Assembly: X21 Page 2 OF 8
Assembly Steps Clear Glass (D) Metal Ring (C) Legs (A) Connecting Rod (B) FRONT FACING This Coffee Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Coffee Table, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 A B C D Place the Legs(A), Connecting Rod(B), Metal Ring(C) and Clear Glass(D) onto a clean, non-marring surface. Step 2 Attach Connecting Rod(B) to Legs(A) using Bolts(①) with Allen Key(②) as shown above. Do not fully tighten the Bolts. You should have an adult partner assist with this process.
Step 3 Align Legs(A) to mounting positions of Metal Ring(C). Then attach Legs(A) to Metal Ring(C) using Bolts(①) with Allen Key(②) as shown above. Do not fully tighten the Bolts. You should have an adult partner assist with this process. Step 4 4.1) Stand the Coffee Table frame up, then insert Anti-skid Pads(③) into the Metal Ring(C) as shown above.
Side with Sloping Edge Up 4.2) Carefully place the Clear Glass(D) onto Metal Ring(C) as shown above. Note: The side with the sloping edge should face upward. You should have an adult partner assist with this process. Step 5 Adjust the Pre-installed Levelers on the bottom of Legs(A) until the Coffee Table is level with the ground.
Step 6 Inspect and make sure all parts are connected and fully secured into position. Your Coffee Table is ready for use. This Coffee Table can only be used on a flat, level surface.
Page 8 OF 8
