Installation & Assembly

WATER FILLED UMBRELLA BASE
Please read instructions thoroughly before assembling.
Familiarize yourself with the parts and the accompanying
illustrations to ensure safe and proper assembly.
Don't fasten the screws and bolts tightly until all the
screws and bolts are assembled in place.
Repeated assembly can weaken the locking ability of the
nuts.
Periodically check all bolted connections to make sure
they are tight and secure.
Part List
x 4
Step 1
Water/Sand
Step 2
Step 3
FOR OFFSET CANTILEVER UMBRELLA
Fill the base with sand or water
to increase the weight.
Warning:
Only fill with water when used in warm climates.
Do not fill with water if exposed to freezing temperatures.
Formation and expansion of ice may crack the base.
Plece the water of sand filled base snug into a corner
of the umbrella stand as shown in the diagram.
Note:It is recommended to use 4 plastic bases to
properly weigh the umbrella base to the ground.