ASSEMBLY INSTRUCTIONS 1 OF 13
BOARD IDENTIFICATION 2 OF 13
BOARD IDENTIFICATION 3 OF 13
4 OF 13
STEP 1 - Screw cam bolts (B) into panel (1) & (6) & (7) as below shown. - Lock the rebounder (G) to the panel (1) with the screw (E) as shown in the picture. (Attention: Cam bolt & Insert nut need to be put together) STEP 2 - Screw cam bolts (B) into panel (2) as below shown. -Lock the rebounder (G) to the panel (2) with the screw (E) as shown in the picture.
STEP 3 - Attach panel (6) & (7) to (8) & (9) with cam locks (A). STEP 4 - Attach panel (6) & (7) & (8) & (9) to (2) with cam locks (A).
STEP 5 - Stick LED band to the side of the base. - Fasten the LED band with buckles.
STEP 7 - Install drawer track (C) to panel (3) & (4)with screws(E). STEP 8 - Screw cam bolts (B) into panel (3) & (4) as below shown. - Insert wood dowels (H) into panel (3) & (4) as shown in the picture.
STEP 9 - Attach panel (5) to (3) & (4) with cam locks (A). STEP 10 - Insert (14) into the slot as below shown.
STEP 11 - Attach panel (2) to (3) & (4) with cam locks (A). STEP 12 - Attach panel (1) to (3) & (4) with cam locks (A).
STEP 13 - Attach panel (12) to (10) & (11) with screw (F) as shown in the picture. - Screw cam bolts (B) into panel (13) & (16) as below shown. (Attention: Cam bolt & Insert nut need to be put together) STEP 14 - Insert panel (15) into the grooves. - Attach panel (13) & (16) to (10) & (11) with cam locks (A).
STEP 15 - Install drawer track (D) to panel (10) & (11)with screws(E). STEP 16 - Insert the drawers.
STEP 17 -Connected pin of LED and power adapter to the RGB control box as below. -Remove the battery protection pad from remote controller. Align romote controller to the RGB Control box to adjust the color mode. Specifications of battery:cr2025 3v STEP 18 - Installation complete.
