DESK Thank you for purchasing Before you start, here is some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step by step Instructions. 2. Owing to the size and weight of the desk, we recommend that it is assembled by two adults, on a carpeted or padded area, In the room that It Is Intended for. Approximate assembly time: 45 minutes. 3. Please do not use any tools other than those provided or recommended in these instructions. 4.
DESK Component: A Cc E Top Panel Right Side Panel Back Pans! Shelf Center All Left Side Panel Bottom Panel Divide Panel Leg Support Rail x1 x1 x2 Page 20f 7
DESK EE ane TO USE CAN AND CAM POST HARDWARE 1. 2. Note cam arrow STEP 1: Insert Sp cs Cam Posts (a) into the corresponding holes on the Left Side Panel (B) as shown. Repeat the same steps for the Right Side Panel (C).
DESK STEP 2: Place the Divide Panels {F) to the Shelf {G}. Connect them by using PCs Dowel {c) as shown. Hardware & Tools required STEP 3: Place the assembled Divide Panels (F) fo the Bottom Panel (D}. Connect them by using PCs Dowel (c) as shown.
DESK STEP 4: Attach the Back Panel (E) to the Bottom Panel (D) by using PCs Screw (g) as shown Usa Allen Wrench (h) to tighten the Screws (g) clockwise until secure. Place the Top Panel (A) to the Assembled Divide Panels (F). Attach them by PCs Dowel (c) as shown. = gee =| cxd x2 hx Hardware & Tools required STEP 5: Place the Left Side Anal {B) and Right Side Panel (C) to the assembled Bottom Panel {D} and Back Panel {E). Attach them by using PCs Dowel {c) as shown.
DESK STEP 6: Attach the PCs Leg (H) to the Center All (J) by using Bolts (} as shown. Tighten Bolts {f} by using Allen Wrench (h}. Do not full tighten. ] x2 hx1 Hardware & Tools required STEP: Attach the 1pc Support All (K) to the assembled Center All (J) by using 1pc Bolt (d). Attach the 1pc Support Rail (K) to the assembled Legs (H) by using 1pc Bolt {e). Usa Allen Wrench (h} to tighten the Bolts (d&s) clockwise until secure. Repeat the same step for the other Support All (J).
DESK STEP 8: Place the Assembled Bottom Panel (D) to the assembled Legs (H) as shown. Attach them by using PCs Bolt {e) as shown. Use Allan Wrench (h) to full tight the Bolts (e). STEP 9: Assembly is completed.
