Assembly Instructions CHAIR CAUTION: You should read this before proceeding Please look in the Seat Panel for hardware packs CAUTION: This Chair is NOT a TOY. Keep your child/children at bay in the process of assembly. For turning the Chair and to prevent damage to the Chair, 02 people may be needed to execute this action.
Parts List Label Picture Description Right Leg Panel With Pre-installed Levellers A Left Leg Panel With Pre-installed Levellers B Seat Panel C Backrest Panel D Back Cushion E Seat Cushion F Qty 1 1 1 1 1 1 Hardware Label Picture Description Qty ① Bolt (M6*35mm) 9 ② Allen Key 2 2 of 8
Assembly Preparation Assembly Steps OVERVIEW Back Cushion (E) Backrest Panel (D) Seat Cushion (F) Seat Panel (C) Left Leg Panel With Pre-installed levellers (B) Right Leg Panel With Pre-installed levellers (A) FRONT FACING This Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Chair, the above picture is to help you put the various parts into perspective.
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 FRONT Position the Seat Panel(C) to the Right Leg Panel With Pre-installed Levellers(A) as shown in the above picture. Then secure the Seat Panel(C) to the Right Leg Panel With Pre-installed Levellers(A) using 2 Bolts(①) and the Allen Key(②). Do not fully tighten the Bolts at this time. Notice: Two wood brackets under the Seat Panel(C) are in the front direction when assembling.
Step 3 Position the Seat Panel(C) and the Right Leg Panel With Pre-installed Levellers(A) to the Left Leg Panel With Pre-installed Levellers(B) as shown in the above picture. Then repeat the same process of Step 2 to secure the Seat Panel(C) to the Right Leg Panel With Pre-installed Levellers(B) using 2 Bolts(①) and the Allen Key(②). Do not fully tighten the Bolts at this time. Step 4 Place the Backrest Panel(D) into the Seat Panel(C) as shown in the above picture.
Step 5 Adjust high for balance Adjust low for balance Adjust the height of the Preinstalled Levellers for balance Stand the Chair up with the assistance from your adult partner. Exert pressure floorwards onto the Chair with both your hands. This pressure will help the Legs and Chair reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured. When tightening the Bolts, tighten sequentially.
Step 7 Tie the velcro straps on the Back Cushion(E) and the Seat Cushion(F) to the Backrest Panel(D) and the Seat Panel(C) as shown in the above picture. Turn the Chair right side up. Your Chair is ready for use. This Chair can only be used on a flat, level surface.
of 8
