Owner Manual (Side Table)

ManualsBrandsWade Logan Manuals2 Person Patio Conversation SetsIsaacson Solid Wood 2 - Person Seating Group with Cushions

CAUTION: You should read this before proceeding

CAUTION: This Table is NOT a TOY.

Keep your child / children at bay in the process of assembly.

For turning the Table and to prevent damage to the Table, 02 people may be

needed to execute this action.

Please look in the Table Top for hardware packs

SIDE TABLE

Assembly Instructions

1 of 6

Summary of content (6 pages)

PAGE 1
Assembly Instructions SIDE TABLE CAUTION: You should read this before proceeding Please look in the Table Top for hardware packs CAUTION: This Table is NOT a TOY. Keep your child / children at bay in the process of assembly. For turning the Table and to prevent damage to the Table, 02 people may be needed to execute this action.
PAGE 2
Parts List Label Picture Description Qty A Table Top 1 B Leg 4 Description Qty ① Bolt (M8*45mm) 9 ② Allen Key 2 ③ Washer 9 Hardware Label Picture 2 of 6
PAGE 3
Assembly Preparation Before Beginning Assembly: Assembly Steps OVERVIEW Table Top (A) Leg (B) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 With assistance from your adult partner, place the Table Top(A) facedown onto a clean, non-marring surface. Attach the Leg(B) to the Table Top(A) using 2 Bolts(②), Washers(③) and the Allen Key(①). Do not fully tighten the Bolts at this time. Repeat the same process with the remaining three Legs(B).
PAGE 5
Step3 Stand the Table up, with assistance from your adult partner. Exert pressure floorwards, onto the Table with both your hands. This pressure will help the Legs and Table Top reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured. When tightening the Bolts tighten sequentially. Do not tighten any Bolt fully and then move on towards the next one.
PAGE 6
of 6