Owner Manual

Q2
01
02
O
O
O
Q2
Q2
Q4
Q
Q4
01
Check the manual that comes
with the Light Fixture Kit
before plugging it in.
Attention
7
19 5/8"
Example:
If you want the panel to be 19 5/8" from the floor:
Height of the first hole line = 19 5/8"+13 1/4"=33"
Height of second hole line = 33"+16 3/8"=49 1/4"
12
Step
th
13
Step
th
Light fixture
Kit
Wire hole
cover
Light fixture
Kit
12
Step
th
There is a wall drilling template printed on the box.
I
08
N
08
Bushing
WALL
X = HEIGHT YOU
WANT FROM THE FLOOR
X
X+13 1/4"
16 3/8"
FLOOR
N
8
I
T
ape
Tape
Put the template
on the wall with tape
Drill the wall
according
to the template
W
all drilling template
Level the rulers
in the wall.
8 holes with
Ø8mm drill
11 1/2"
16"
16"
16"
W
all drilling template
1/4" x 2 1/2"
Screw
Studs
Stud
Finder
Wall Mounting Points
Wall panel must be solidly attached to your wall. Make sure
that you locate the studs behind the wallboard. Mark where
the center of each stud is located and make sure you hit the
stud with the wood ‘’I’’ screws.
Studs are usually 16" (406mm) apart from the center of one
to the center of another. Using a Stud Finder is the easiest
way to locate studs.
The recommended method of installation is to fasten the
panel to wooden wall studs.
If you cannot locate wooden wall studs, consult your
local hardware store for advice on the best type of wall
anchors for your installation.