Assembly Instruction

ManualsBrandsWade Logan ManualsBar FurnitureMacaire 24.21" Counter Stool

Table Of Contents

ASSEMBLY INSTRUCTION

Back Rest

1pc

Front Leg Frame

1pc

Side Rail -

LSF/RSF

2pcs

Cushion

1pc

Jcbc Bolt

M6 x 50mm

Flat Washer

M6 x 13mm

Pan Head Screw

M4 x 32mm

Spring Washer

6 pcs

8 pcs

Allen Key

M4 x 110

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly, place the

contents on a carpeted or padded area to protect

them from damage.

1pc

Stretcher

2pcs

24" COUNTER HEIGHT CHAIR

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTION 24" COUNTER HEIGHT CHAIR Back Rest Front Leg Frame Side Rail LSF/RSF Cushion 1pc 1pc 2pcs 1pc Stretcher Jcbc Bolt M6 x 50mm Spring Washer M6 Flat Washer M6 x 13mm 2pcs 6 pcs 6 pcs 6 pcs Pan Head Screw M4 x 32mm 8 pcs Allen Key M4 x 110 1pc This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product.
PAGE 2
Put the Back Rest (A) upside down on the soft and smooth surface.With assistance attach Side Rail - LSF/RSF (C) onto Back Rest (A). Insert Stretcher (E) into hole on Back Rest (A). Then insert Jcbc Bolt (F), Spring Washer (G) and Flat Washer (H) into predrilled holes of each Side Rail, by using Allen Key (J). Do not fully tighten the bolts in this step. Take the Allen Wrench, and turn the bolts until the legs are secure. DO NOT TIGHTEN COMPLETELY.
PAGE 3
Stand chair up on an even surface and check that it is balanced. If there is a slight wobble, apply downward pressure on each corner where a leg is uneven. Keeping pressure in that corner, tighten all bolts. If balanced, apply downward pressure evenly in the center and tighten all bolts. Tighten all JCBC by using Allen Key (J). While the chair legs uneven after assembled, please adjust the adjustable glide to make it balance.
PAGE 4
Attach Cushion (D) with Pan Head Screw (I) by using Screwdriver (not included). Tighten all wood screws in this step. Cleaning & Care Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections are tight.