ASSEMBLY INSTRUCTIONS 1 OF 13
BOARD IDENTIFICATION 2 OF 13
BOARD IDENTIFICATION 3 OF 13
4 OF 13
STEP 1 - Attach panel (12) to (1) with bolts (I). STEP 2 - Screw cam bolts (B) into panel (1) & (2) as below shown.
STEP 3 - Screw cam bolts (B) into panel (3) & (4) as below shown. - Insert wood dowels (J) into panel (3) & (4) as shown in the picture. (Attention: Cam bolt & Insert nut need to be put together) STEP 4 - Attach panel (3) & (4) to (5) with cam locks (A).
STEP 5 - Insert (13) into the slot as below shown. - Attach panel (2) to (3) & (4) with cam locks (A). STEP 6 - Attach foot(N) to panel (2) with screw (L).
STEP 7 - Install drawer track (E) & (F) to panel (3) & (4) with screws (C). STEP 8 - Stick LED band to the side of the back.
STEP 9 - Insert (10) into the slot as below shown. - Attach panel (1) to (3) & (4) with cam locks (A). STEP 10 - Screw cam bolts (B) into panel (9) as below shown.
STEP 11 - Attach panel (6) & (7) to panel (8) with screw (K) . STEP 12 - Insert panel (11) into the grooves. - Attach panel (9) to (6) & (7) with cam locks (A).
STEP 13 - Install drawer track (G) & (H) to panel (6) & (7) with screws (C). STEP 14 - Install handle (M) to panel (9) with bolts (D).
STEP 15 - Insert the drawers. STEP 16 -Connected pin of LED and power adapter to the RGB control box as below. -Remove the battery protection pad from remote controller. Align romote controller to the RGB Control box to adjust the color mode.
STEP 17 - Installation complete.
