Manualshelf

Owner Manual

ManualsBrandsWade Logan ManualsCeiling LightsBradburn 1 - Light
1234
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
Risk of Fire. Consult a qualified electrician to ensure correct branch circuit conductor.
Minimum 90°C supply conductors.
Turn off the main power at the circuit breaker before installing the fixture, in order to
prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain
the services of a qualified electrician.
Remove the fixture and the hardware package from the box and make sure that no parts
are missing by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION
LED CEILING FLUSH MOUNT
1. Outlet Box
2. White Supply Wire
3. Black Supply Wire
4. Supply Ground Wire
5. Ceiling Anchor
6. Mounting Screws
7. Wire Nut
8. Black Fixture Wire
9. White Fixture Wire
10. Fixture Pan
11. Fixture Ground Wire
12. Acrylic Shade
13. Frame
14. Thumb Nuts
15. CCT Switch
1. Place the fixture pan (10) onto the desired location, centering it over the outlet box
(1). Mark the location of all the keyhole slots. Remove the fixture pan (10) from the
ceiling. Drill appropriately 1/4” sized holes at the marked keyhole locations. Insert the
ceiling anchors (5) into the holes.
2. Thread the mounting screws (6) halfway into the ceiling anchors (5).
3. Pull the power supply wires out from the outlet box (1). Connect the black supply
wire (3) to the black fixture wire (8) using a wire nut (7). Connect the white supply
wire (2) to the white fixture wire (9) using a wire nut (7). Connect the fixture
ground wire (11) and the supply ground wire (4) together using a wire nut (7).
Wrap all wire connections with electrical tape for a more secure connection. Carefully
tuck all the wires and wire connections into the outlet box (1).
4. Place the fixture pan (10) over the outlet box (1) and feed the mounting screws (6)
through the keyhole slots. Slide the fixture pan (10) so that the mounting screws (6)
slide into the narrow slots of the keyhole slots.
5. Tighten the mounting screws (6) so that the fixture pan (10) is secured flush
against the ceiling.
6. Set the CCT switch (15) to the desired color temperature.
7. Secure the acrylic shade (12) and the frame (13) to the fixture pan (10) using the
thumb nuts (14).
1
5
6
7
10
12
13
14
3
8
9
11
2
4
6
15

Summary of content (4 pages)