ASSEMBLY INSTRUCTIONS 1 OF 13
BOARD IDENTIFICATION 2 OF 13
BOARD IDENTIFICATION 3 OF 13
4 OF 13
STEP 1 - Screw cam bolts (B) into panel (4) as below shown. (Attention: Cam bolt & Insert nut need to be put together) STEP 2 - Screw cam bolts (B) into panel (5) as below shown. -Lock the rebounder (J) to the panel (5) with the screw (E) as shown in the picture.
STEP 3 - Screw cam bolts (B) into panel (1) & (2) as below shown. - Insert wood dowels (C) into panel (1) & (2) & (3) as shown in the picture. (Attention: Cam bolt & Insert nut need to be put together) STEP 4 - Screw cam bolts (B) into panel (7) as below shown. - Insert wood dowels (C) into panel (7) & (13) as shown in the picture.
STEP 5 - Attach panel (7) to (13) with cam locks (A). STEP 6 - Attach panel (7) & (13) to (5) with cam locks (A).
STEP 7 - Stick LED band to the side of the base. - Fasten the LED band with buckles. STEP 8 - Attach panel (1) & (2) to (6) with cam locks (A).
STEP 9 - Attach panel (1) & (2) & (3) to (5) with cam locks (A). STEP 10 - Install drawer track (F) & (G) to panel (1) & (2) with screws (E).
STEP 11 - Attach panel (4) to (1) & (2) & (3) with cam locks (A). STEP 12 - Attach panel (11) to (9) & (10) with screw (D) as shown in the picture.
STEP 13 - Screw cam bolts (B) into panel (8) & (14) as below shown. (Attention: Cam bolt & Insert nut need to be put together) STEP 14 - Insert panel (12) into the grooves. - Attach panel (8) & (14) to (9) & (10) with cam locks (A).
STEP 15 - Install drawer track (H) & (I) to panel (9) & (10) with screws (E). STEP 16 - Insert the drawers.
STEP 17 -Connected pin of LED and power adapter to the RGB control box as below. -Remove the battery protection pad from remote controller. Align romote controller to the RGB Control box to adjust the color mode. Specifications of battery:cr2025 3v STEP 18 - Installation complete.
