ASSEMBLY INSTRUCTIONS 1 OF 10
BOARD IDENTIFICATION 2 OF 10
BOARD IDENTIFICATION 3 OF 10
4 OF 10
STEP 1 - Attach panel (6) to (5) with screw (F) as shown in the picture. STEP 2 - Screw cam bolts (B) into panel (3) as below shown.
STEP 3 - Attach panel (3) to (2) with cam locks (A). STEP 4 - Stick LED band to the side of the panel (2) & (3).
STEP 5 - Fasten the LED band with buckles. STEP 6 - Attach panel (2) & (3) & (4) to (1) with bolt (E).
STEP 7 - Screw cam bolts (B) into panel (4) as below shown. STEP 8 - Attach panel (5) & (6) to (4) with cam locks (A).
STEP 9 -Attach the sticker (C) to the lock as shown below. STEP 10 -Connected pin of LED and power adapter to the RGB control box as below. -Remove the battery protection pad from remote controller. Align romote controller to the RGB Control box to adjust the color mode.
STEP 11 -Attach the adapter to the laminate on the laminate (4), as shown below. -Connect the power supply through the laminae (4) to the adapter as shown below. -Direct the remote control to the adapter , as shown below. STEP 12 - Installation complete.
