Installation & Assembly

4) Make wire connections. Reference chart below for correct con-
nections and wire accordingly.
5) Pushxturetowall.Placecanopyofxtureovertabson
mounting bracket
 NOTE:Becertainwiresdonotgetpinchedbetweencanopy
andmountingstrap.
6) Threadonescrewintoholeontopandbottomofcanopy.
Tightenscrewstosecurextureinplace.
7) Insertrecommendedbulb.(Notsupplied).
1) Findtheappropriatethreadedholesonmountingstrapthat
alignwithholedistanceincanopy.Threadmountingscrews
intothreadedholesstartingfromoutletboxside.
2) Attachmountingstraptooutletboxwithstrapmounting
screws.Mountingstrapcanbeadjustedtosuitpositionof
xture.
3) Grounding instructions: (See Illus. A or B)
 A) Onxtureswheremountingstrapisprovidedwithahole
andtworaisedimples.Wrapgroundwirefromoutletbox
around green ground screw, and thread into hole.
 B) Onxtureswhereacuppedwasherisprovided.Put
groundwirefromoutletboxundercuppedwasherand
green ground screw and thread screw into hole in mount-
ingstrap.
 Ifxtureisprovidedwithgroundwire.Connectxtureground
wiretooutletboxgroundwirewithwireconnector,afterfollow-
ingtheabovesteps.Neverconnectgroundwiretoblackor
whitepowersupplywires.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth)
*Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
OUTLET BOX
TAB
CANOPY
WIRE
CONNECTOR(S)
MOUNTING
STRAP
STRAP
MOUNTING
SCREW(S)
SCREW(S)
SOCKET
WARNING:
This xture is intended for installation in accordance
with the National Electrical Code (NEC) and all local code
specications. If you are not familiar with code requirements,
installation by a certied electrician is recommended.
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starting and during the installation.