Installation Guide

STEP 5
STEP 2
STEP 4
STEP 1
Turn off the power at the breaker box. Test that the power is off at
the ceiling junction box with a circuit tester.
Mark the position of the hanger's holes on your ceiling.
STEP 3
Drill the ceiling holes for the plastic anchors (2). Install the provided
plastic anchors into the holes you've just drilled. Mount the hanger with
the 4 screws provided. The 3/4" screws (3) are screwed into your
junction box. The 1 1/8" screws (4) are screwed into your plastic anchors.
Connect the power and neutral wires using the provided wire caps.
Connect the white wire from the fixture to the neutral wire in your ceiling
junction box. Connect the black wire to the power wire in your ceiling
junction box. Connect the bare copper ground wire to the green screw
on the hanger.
Mount the fixture ceiling canopy to the hanger using the provided 1/2"
screws (6) as shown.
STEP 7
Turn your power back on at the breaker box.
STEP 6
5
5
6 6
Installation Guide
! WARNING - Turn off the power at the breaker box before starting any work.
Failure to do so can result in bodily harm.
We strongly recommend that a licensed electrician performs the installation.
Ensure that all safety and jurisdiction code is followed up to the highest standard.
Parts component list
All support lines should be at the same height. Push the lock nuts up to
release the lines and pull through accordingly. Release once your height
is set and tighten the hex screw with the allen key on the inside of the
canopy to lock the nut and keep the lines in place.
1
2
2
3
3
4 4
1
1x
1
Allen key 2.0mm
2x +
1 extra
1 1/8"
2 3 4 5
2x +
1 extra
3/4"
2x +
1 extra
1 1/8"
2x +
1 extra
6
2x
1/2"