Installation & Assembly

ASSEMBLY INSTRUCTIONS:
VERY IMPORTANT
WARNING: MAKE SURE POWER SUPPLY IS TURNED OFF AT MAIN
BREAKER PRIOR TO INSTALLATION. PLEASE READ THOROUGHLY.
CAREFULLY UNPACK THIS LAMP AND PLACE ON A SOFT FLAT
SURFACE.
1. Remove the finial (9) from canopy (8) and take out the mounting plate (10).
2. Fasten the mounting plate (10) to junction box with screws (11).
3. Align the glass shade (4) according to the drawing, attach metal plate (3), glass shade (4)
and metal plate (6) tighten with nuts (7).
4. Install the bulb (1) into socket (2).
5. Put the glass shade (4) under the canopy (8), tighten with nuts (5).
6. Secure the thread (12) to the canopy (8).
7. Attach the glass plate (13) to the thread (13) with the washer (14) and nuts (15).
8. Connect the GROUND WIRE from the canopy (8) and fixture to the Ground wire from
junction box; make the electrical connections using the wire nut. (Or attach them to the
mounting plate (10) with the green Ground screw). Connect the NEUTRAL wire (Or
WHITE) from fixture to wire (NEUTRAL) from power supply with the wire nuts.
Connect the LIVE wire (Or BLACK) from fixture to wire (LIVE) from power
supply with the wire nut.
9. Attach the canopy (8) to mounting plate (10) and tighten by finial (9).
※ PLEASE INFORM YOUR DEALER IMMEDIATELY IN CASE OF ANY PARTS SHORTAGE.
※ SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Use 3pcs 60W (Maximum) Incandescent G type frosted bulb. (Bulbs included)
2. SOCKET
1. BULB
14.WASHER
4. GLASS
SHADE
8.CANOPY
9.FINIAL
4. GLASS
SHADE