Installation Instructions & Operating Manual READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE. WARNING! To reduce the risk of fire, electric shock, or personal injury, read all the instructions before using this heater.
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire， electrical shock，and injury to persons including the following： 1. Read all instructions before using this appliance. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.
INSTALLATION INSTRUCTION TOOL REQUIRED Magnetic Phillips Screw Driver UNPACKING THE ELECTRIC FIREPLACE ● ● ● ● ● WARNING! Do NOT use this Electric Fireplace if any part has been under water. Immediately call a qualified service technician to inspect and to replace any part of the electrical system if necessary. Keep plastic wrapping away from children. Open the packaging carefully and remove the foam. Remove and discard the plastic bag. Be responsible when handling the packing materials.
unit: mm W1 W2 W3 855 895 924 1055 1095 1124 1355 1395 1424 1555 1595 1624 1955 1995 2024 LOCATING YOUR ELECTRIC FIREPLACE Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location ensure that the general instructions are followed. For best results, install out of direct sunlight. Power supply service must be either completed or placed within the electric fireplace prior to finishing to avoid reconstruction.
FITTING DECORATIVE STONES Ensure the appliance is unplugged. First remove the trim, the trim is held on by magnets, Put gently forward to remove, see Diagram 1. ● ● There is a clamp at the top of glass viewing panel that secure the glass in place, see Diagram 2. Supporting the glass, loosen and remove the 2 clamps. These can be unscrewed using just finger tips. ● ● ●Carefully tip the glass forward and lift out of the lower tray to remove from the appliance.
ELECTRICAL SPECIFICATIONS Voltage ………………………………..120V AC, 60 Hz Total Amps ……………………………..... … 10.8AMP Total Watts …………………………….……1300Watts ELECTRICAL CONNECTION WARNING! Electrical wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electrical shock and injury. Note: All wiring must be completed prior to finishing the unit. EXISTING APPLIANCE INSTALLATION Plan the power supply.
MAINTENANCE WARNING: ALWAYS DISCONNECT POWER BEFORE SERVICING. DO NOT IMMERSE HEATER IN WATER! Always turn OFF the heater and disconnect power before cleaning your heater. Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner. Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a solution of mild detergent and water. Dry the case thoroughly before operating the heater.
Flame button The fire has four flame effects and a standby, by pressing the flame effect button the unit will cycle through each condition. Heater button Press once turns 650W power on. (Pilot lights illuminated ●○) Press again turns 1300W power on (Pilot lights illuminated ●●) Press third time turns heater off. (Pilot lights illuminated ○○) To Reset the Heater Your heater includes a protection system that shuts off the heater if it overheats for any reason: 1) Turn unit to off. 2) Wait 5 minutes.
WARRANTY In the unlikely event of a problem occurring due to a manufacturing fault within 24 months from the date of purchase of the appliance it will be repaired or replaced free of charge. This warranty does not cover consumable items such as the bulbs and fuses which have a limited lifespan. If a problem should occur, the nature of the problem together with the date of a purchase should be immediately reported to the retailer that the appliance was purchased from.
