Owner Manual

4
Preparation
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for wall-hanging use. Check the parts list to make sure nothing is
missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape
measure; electric drill; 1/4” wood drill bit, hammer.
Parts and Hardware
A – Fireplace ( 1 )
B – Wood Screws ( 6 )
C – Drywall anchors (6 )
D – ST4x8 Metal Screws (2)
RC – Remote Control
E - Wall Bracket (1)
F - Decorative Crystals
Installation and Assembly
Rear View of Fireplace
Minimum 39.4”
(100 cm)
19.7”
(50 cm)
19.7”
(50 cm)
Minimum 19.7”
(50 cm)
Step 1. Find a safe location.
Minimum clearance on each side: 19.7” (50
cm).
Minimum clearance below: 19.7” (50 cm).
Minimum clearance above: 39.4” (100 cm).
Minimum clearance from the front and sides:
3 feet (90 cm).
Choose a location near an outlet so an
extension cord is not required.
DO NOT position the unit directly below a
power outlet.
See Safety Information on pages 2 and 3
for warnings about safe placement, safe
installation, and proper use of this product.
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.