Owner`s manual

14
Your Wadia 321 has been factory configured allow-
ing for immediate enjoyment of superb audio. If you
wish to make changes to the factory default settings, a
Setup Feature is provided to customize the operation
by using the Front Panel Information Display. Refer to
the 321 Front Panel Illustration on the previous page
while performing the following steps.
Note: If the 321 is currently On, proceed to step 2.
1. Press the STANDBY/ON Push-button on the Front
Panel or press the MODE (Power) Push-button on
the Remote Control to switch On the 321. The 321
will go through a brief startup intialization with
the Front Panel Display indicating the last used
Input Source and volume setting. Refer to figure 1.
2. Press the SETUP Push-button repeatedly until the
Front Panel Information Display indicates “Firm-
ware V1.00” or higher. Refer to figure 2.
3. Press the SETUP Push-button to exit from the
Setup Mode. The LED above the SETUP Push-
button will extinguish and the Front Panel Display
will revert back to its display of Input, Sampling
Frequency and Volume %. Refer to figure 1.
The 321 functionality is controlled by internal soft-
ware know as “Firmware”. The current Version of
the Firmware can be identified by utilizing the Setup
Mode.
1. Repeatedly press the SETUP Push-button until
“FIRMWARE V_ _.__” is indicated on the
Front Panel Display. Refer to figure 2.
3. Press the SETUP Push-button until the LED above
the SETUP Push-button is extinguished.
How to Operate the Setup Mode
The Default Settings Chart that follows indicates the
Function Name, Default Setting and the Page Number
for additional information.
Default Settings
Firmware Version
Default Settings
Function Name Setting Page No.
AUTO POWER OFF ENABLED 14
FIR M WA R E V_ _.__ 14
Setup
FIRMWARE V1.00
Figure 2
The 321 incorporates an Auto Power Off Feature,
which can automatically place the Digital Preamplifier
into the Power Saving Standby/Off Mode. This occurs
approximately 30 minutes after there has been an
absence of a Digital Audio Signal on the currently se-
lected 321 Input. If it is desirable to change the default
Auto Off Setting of Enabled to Disabled, perform the
following steps:
1. Press the SETUP Push-button.
2. The Front Panel Display will momentarily indicate
“Auto Power Off”. Refer to figure 3.
3. The display will then indicate the current setting,
either Disabled or Enabled. Refer to figures 4
and 5.
Auto Power Off
AUTO POWER OFF
Figure 3
DISABLED
Figure 5
ENABLED
Figure 4
Figure 1
COAX1 192K 75
VOLUME %
INPUT
SAMPLING FREQUENCY
FIRMWARE V1.00
Figure 2
4. Press the INPUT Push-button to change the cur-
rent setting.
5. Press the SETUP Push-button repeatedly until
the LED above the SETUP Push-button is extin-
guished, the Front Panel Display indicates the cur-
rently selected Input Source. Refer to figure 1.