Owner`s manual

15
brightness preference, High (default setting) or Low Il-
lumination. To change the Brigthness Setting, repeat-
edly press the DISPLAY Push-button on the Remote
Control for the desired Brightness. Refer to figure 56.
Output Phase
Normally, the “Absolute Phase” of recorded music is
“In Phase”. Occasionally the music may be “Out of
Phase” and the 321 can correct this out of phase condi-
tion by pressing the PHASE Push-button on the Re-
mote Control. On the Front Panel Display an “i” will
appear to the right of the Volume
Percentage. Refer to figure 54.
Note: For additional information on
“Absolute Phase” and “Phase
Reversal”, refer to note 5 on
page 5.
USB Input Operation and Driver
Installation
The 321 USB Input provides the
capability to playback music from a
computer when the 321 Rear Panel
USB Connector is connected to a
computer USB Connector. Refer to
figure 55.
Note: The USB Input is for direct connection to a com-
puter only. To playback music from a USB Drive,
connect the USB Drive to another USB Port on
Volume Level
To change the Volume Level of the Wadia 321, press
the Front Panel VOLume + Push-button to increase the
Volume or the VOLume - Push-button to decrease the
Volume. The Volume Level may also be changed by
using the Remote Control (Volume Up) Push-
button or the (Volume Down) Push-button for
the desired listening level. Refer to figures 53 and 56.
Note: A Volume Setting of 88% on the Wadia 321 will
provide optimum performance when it is con-
nected to a Preamplifier (Integrated Amplifier or
Receiver).
Mute
Press the Remote Control MUTE Push-button to mute
the Audio Outputs. Refer to figure 56. When the Wa-
dia 321 is muted, the Front Panel Display will display
a series of dashes where the Volume % is normally
displayed. Refer to figure 52. Pressing the MUTE
Push-button a second time to un-mute the 321.
Display Brightness
The Front Panel Display Brightness may be changed
from the default setting. The 321 will remember the
Power On and Off
The Red LED above the STANDBY/ON Push-button
lights to indicate the 321 is in Standby mode. To
switch ON the 321, press the STANDBY/ON Push-
button on the Front Panel or the MODE (Power On)
Push-button on the Remote Control. The 321 will go
through a brief startup initialization with the Front
Panel Display indicating the last used Input Source
and Volume Level Setting. Refer to figures 50, 53, and
56. To switch OFF the 321 press the STANDBY/ON
Push-button on the Front Panel or the MODE (Power
Off) Push-button on the Remote Control.
Source Selection
Press the INPUT Push-button on the Front Panel
or the INPUT Push-button on the Remote Control
to select the desired source. Refer to figures 53 and
56. When the selected Input Source stops sending a
Digital Audio signal to the Wadia 321, the Front Panel
Display will display a series of dashes where the
Sampling Frequency is normally displayed. Refer to
figure 51.
How to Operate the 321
Figure 53
Figure 56
Figure 50
COAX1 192K 75
VOLUME %
INPUT
SAMPLING FREQUENCY
Figure 54
COAX1 192K 75 |
VOLUME %
INPUT
SAMPLING FREQUENCY
USB 192K 75
VOLUME %
INPUT
SAMPLING FREQUENCY
Figure 55
Figure 51
COAX1 ----- 75
VOLUME %
INPUT
SAMPLING FREQUENCY
COAX1 192K ---
VOLUME %
INPUT
SAMPLING FREQUENCY
Figure 52
How to Operate the 321