Owner`s manual

Wadia 9 Series Decoding Computer System Owner’s Manual

Connecting the 931 and 921

931 Digital Controller Outputs

There are nine outputs on the 931 Controller. One is dedicated for ClockLink and can

be used to connect to a Clocklink enabled source. All of the other outputs can be

configured as either ClockLink or Data outputs. This allows the Wadia 931 Digital

Controller to be used in a variety of system configurations. To change the

configuration of the outputs, see Configurations on page 24.

Below is a drawing of the Wadia 931 Digital Controller digital outputs —

921 Decoding Computer Inputs

The Wadia 921 Mono Decoding Computer has 2 inputs, both ST glass fiber, which

comprise Wadia’s proprietary Dual-fiber Digital Interface. As currently configured,

this interface uses one for data (up to 192 kHz, 24-bit), and one for clock.

Connect the two fiber cables from your Wadia Digital Controller to the ClockLink and

Data input shown below.