Owner`s manual

Wadia 9 Series Decoding Computer System Owner’s Manual

Illuminated Status Indicator

There is a multi-colored LED at the base of the front of the 921 Mono Decoding

Computer. This LED indicates the status of the Wadia 921, as follows:

• Blue Unit is in operate mode

• Red Unit is powered up, but in Standby Mode

• Flashing Red Output protection is engaged (contact your dealer)

921 Mono Decoding Computers Maximum Output Level Setting

For optimum performance, the 921 output level should be set so that critical listening

occurs with the volume control near the top of its range, above 70. The Maximum

Output Level is adjusted by means of a set of switches located on the back panel of

the Decoding Computer, with 4.4 Volts RMS being the loudest setting. If more than

one switch is active, the highest voltage setting will override.

Output Voltage Table:

4.4 Volts RMS Switch 1 On

2.2 Volts RMS* Switch 2 On

1.1 Volt RMS Switch 3 On

0.5 Volts RMS Switch 4 On

*Factory default setting

Note: before adjusting the output level, make sure you put the 921 Mono Decoding

Computers into the Standby Mode. You can put the 9 Series Decoding Computer System

in the Standby Mode by setting the Wadia 931 volume to zero, and pressing mute on the

remote control. For more information, see Standby on page 21.

Output Level

Status Indicator