Owner`s manual

Wadia 9 Series Decoding Computer System Owner’s Manual
22
Volume and Input
The volume can be controlled between 0 and 100. Each increment of 1 on the display
is 0.5 dB, so the attenuation range is from -50 dB at a volume setting of zero, to 0
dB at volume setting of 100. The display jumps to the main screen whenever the
volume or input is changed.
Mute
Mute is engaged by pressing the mute key on the remote control. The volume is set
to zero by sending a stream of zero data to the output, or by interrupting the output.
When entering or leaving mute mode, the volume ramps up or down such that it
takes roughly 2 seconds to get from a volume of 100 to volume 0. Pressing mute or
volume up (but not volume down) disengages mute. Pressing Mute displays the main
screen as shown:
No Data
If there is no digital signal present on the selected input, the display indicates this by
flashing the name of the input alternately with the words “NO DATA”:
level:95 (mute)
in 2:Glass opt ical
Main in MUTE
level:95
in 2:No data
Mai n wi th No
Da t a