User manual

Connecting MT100 MagicTouch MT100

8.2 Connecting MT100 to the central locking system

Supplementary to fig. 6

➤ Connect MagicTouch in accordance with the corresponding circuit diagram (for

details, see table „Keys for the circuit diagrams“ auf Seite 24):

z Vehicles without a servo motor in the driver's door (driver's door cannot be

locked and unlocked from the passenger's door) or with pressure vacuum

central locking without electrical control cable: fig. 7

In these cases, you will require an additional servo motor, WAECO type no.

ML-11 for the driver's door.

z Two cables switching from negative to +12 V: fig. 8

z Two +12 V pulse control cables: fig. 9

z Two negative pulse control cables: fig. 0

z One open and negative pulse control cable: fig. a

z One +12 V and negative pulse control cable: fig. b

z Connection to the WAECO central locking system ML-44(22): fig. c

NOTE

Check whether the indicators flash once upon locking with the remote

control.

If they flash twice, you will need to reconnect the grey/yellow cable to pin 12

and the blue/yellow cable to pin 13 of the control unit.

Keys for the circuit diagrams

NOTE

Pull the plug out before disconnecting the cable bridge.

There is a cable bridge on the plug of the cable set between pin 7 and

pin 11:

z Cable bridge closed (factory setting): for electric servo motors (activation

time: 0.7 s)

z Cable bridge open: for pneumatic servo motors (activation time: 3 s)

No. in fig. 7

to fig. c

Designation

1 Control unit for the vehicle's own central locking system

2 Control switch (driver's door) for the original central locking

system, central locking closed

3 Control switch (driver's door) for the original central locking

system, central locking open

_IA_MT100.book Seite 24 Freitag, 28. Mai 2010 9:04 21