User manual

MagicTouch MT100 Operating MagicTouch

9 Operating MagicTouch

9.1 Using the remote control

See fig. d

Observe the following instructions when you use MagicTouch:

z To ensure the remote control functions properly, a disturbance-free connection

between the hand-held transmitter and the control unit is required.

z Depending on where the control unit is installed, and the transmission power of

nearby sources of interference, the range is up to 20 m.

z Each time the hand-held transmitter is used, it sends a new code (rolling code).

For this reason, the control unit might not recognise the hand-held transmitter

immediately if you use the hand-held transmitter too frequently without the con-

trol unit receiving the transmission signal. In this event, press the hand-held

transmitter again another one to three times; after the third attempt at the latest,

the control unit will detect the hand-held transmitter again.

To close the central locking:

➤ Press the “Close” button on the hand-held transmitter.

✓ If the ignition is switched off, the hazard light flashes once for confirmation.

✓ If installed (accessory): The status LED starts flashing.

To open the central locking:

➤ Press the “Open” button on the hand-held transmitter.

✓ If the ignition is switched off, the hazard light flashes twice for confirmation.

✓ If installed (accessory): The status LED goes out.

9.2 Replacing the battery

See fig. e

You must replace the batteries:

z when the range of the hand-held transmitter decreases distinctly, or

z when the control LED flickers during transmission or

z when, after opening, the hazard lights flash quickly 5 times. In this case, replace

the battery within one month.

Please observe the following instructions for batteries:

WARNING!

Children could swallow batteries. Keep the batteries out of reach of chil-

dren.

z Only use leak-proof batteries that are suitable for electronic devices.

_IA_MT100.book Seite 33 Freitag, 28. Mai 2010 9:04 21