User manual

EN
Using the parking aid WPS900F/WPS910
42
The front sensors are deactivated when
 the speed of the vehicle is more than 10 km/h
 you press the external button or the right button on the control unit briefly
Press one of the two button for at least 5 s to deactivate the front sensors
until the next time the vehicle is started.
A
A
I
NOTICE!
Stop the vehicle immediately and investigate the situation
(getting out if necessary), if the following happens while you are
manoeuvring:
the device first indicates an obstacle and the tone sequence
speeds up normally (e.g. from slow to medium) when manoeu-
vring. The signal tone suddenly slows down, or no obstacle is
indicated at all.
This means that the original obstacle is in the blind spot of the
sensors (construction-related characteristic), and there is still a
potential for collision.
NOTICE!
Be especially careful when manoeuvring after the system has
been disconnected from the front or rear sensors.
The system will indicate this fault by:
 the speaker will emit a double alarm tone.
 the red LED in the control unit and the LED on the external
button flash continuously.
NOTE
When the stop zone is reached, the volume of the continuous tone
will fall by about 50 % after a short time.