User manual

Connecting the power to MagicSafe MagicSafe MS660
70
➤ Screw the rear wall to a suitable installation location.
➤ Put the housing back onto the rear wall and click it into place.
6.9 Installing the gas detector MSG150 (accessory)
➤ Install the gas detector as described in the relevant operating manual.
7 Connecting the power to MagicSafe
A
NOTICE!
For vehicles with catalysers, you must shut down the fuel pump
while making the electrical connections.
The complete circuit diagram for the alarm system can be found in fig. a,
page 6.
No. Designation
1 9-pin connection cable plug (CL)
2 15-pin connection cable plug (alarm)
3 Convenience output
4 Alarm siren with backup function (MS-670SI)
5 Earth-controlled input for optional accessory modules
6 Earth-controlled output for optional accessory modules
7 Start lock (e.g. for the fuel pump, for the starter) or horn/siren (MS-620SI)
8 Bonnet contact switch
9 Start lock (e.g. for the fuel pump, for the starter) or horn/siren (MS-620SI)
10, 11 Indicator
12 Antenna
13 Vehicle battery (starter battery)
14 Connected positive terminal (ignition, terminal 15)
15 3-pin plug for connection to the ultrasonic module
16 Ultrasonic sensors
17 Red plug connection ultrasonic sensor – ultrasonic module
_MS660.book Seite 70 Montag, 2. August 2010 8:03 20