User manual

Programming MagicSafe MagicSafe MS660
86
Function 24 (Visual signals)
A connection to the indicator cables has been provided at the factory. In the
event of an alarm, both alarm system indicator outputs generate a +12 volt
interval signal.
If you wish to connect the optical signals via the hazard lights switch, you
must program this to “Hazard lights”. In this case, a short earth signal is
switched from both alarm system indicator outputs. After the alarm has
finished (30 sec.), a further earth signal is switched to deactivate the hazard
light system.
9.3 Programming
Starting the programming mode
➤ Deactivate the alarm system using the remote control: Press the “Unlock”
button.
➤ Open the driver's door and switch on the ignition.
➤ Press and hold the “Unlock” button and switch the ignition off.
➤ Release the “Unlock” button.
✓ The status LED lights up. You have now accessed the program menu.
I
NOTE
If 30 sec. elapse without a button being pressed, the program menu
will be quit automatically.
Programming functions
The functions are programmed by pressing the button “Lock” or “Unlock” re-
peatedly in accordance with the number of the function, see list, page 81.
Example: You wish to activate the convenience locking function. This is
function 4. Press the “Unlock” button 4 times to activate.
The status LED goes out briefly each time the button is pressed to confirm
the selection. To confirm the programming step, the status LED goes out for
2sec.
The preferred value is saved.
➤ Perform all the required programming steps.
➤ To end programming, switch the ignition on.
_MS660.book Seite 86 Montag, 2. August 2010 8:03 20