User manual

MagicSafe MS660 Using MagicSafe
93
Reading the PIN code
Once all hand-held transmitters and radio sensors (accessory) have been
learned, the status LED starts to flash after 10 sec. This sequence shows the
new, updated PIN code.
➤ Take a reading of the current PIN code.
Example:
Status LED flashes 10 x, then 2 sec. pause = number 0
Status LED flashes 1 x, then 2 sec. pause = number 1
Status LED flashes 2 x, then 2 sec. pause = number 2
Status LED flashes 3 x, then 2 sec. pause = number 3
Status LED flashes 4 x = number 4
The system PIN code is 0 1 2 3 4.
I
NOTE
z Make a note of the PIN code and keep it in a safe place (e. g. at
the end of this manual, see page 101)!
z The PIN code is changed every time the hand-held transmitters
are learned.
Exiting learning mode
➤ Switch on the ignition.
➤ Switch the ignition off.
➤ If you connected the yellow cable belonging to MS660 to an earth point
for the programming process, you now need to remove this connection.
➤ Insulate and store the yellow cable.
Testing the hand-held transmitter
➤ Test the new hand-held transmitter.
If a hand-held receiver does not function, then they must all be learned
again.
_MS660.book Seite 93 Montag, 2. August 2010 8:03 20