User manual

EN
Cleaning and caring for the inverter SinePower
52
11 Cleaning and caring for the inverter
A
➤ Occasionally clean the product with a damp cloth.
12 Troubleshooting
!
I
The LED (fig. 5 2, page 4) lights up red to indicate the fault:
NOTICE!
Do not use sharp or hard objects or cleaning agents for cleaning
as these may damage the product.
WARNING!
Do not open the device. You risk sustaining an electric shock by
doing this.
NOTE
If you have detailed questions on the specifications of the in-
verter please contact the manufacturer (addresses on the back of
the instruction manual).
LED display Cause Remedy
Quick flash Input voltage is too high Check the input voltage and reduce
it.
Slow flash Input voltage too low The battery needs recharging.
Check the cables and connections.
Occasional flash Overheating Switch off the inverter and the con-
sumer.
Wait 5 to 10 minutes and switch the
inverter on again without any electric
consumers.
Reduce the load and make sure the
inverter has better ventilation. Then
switch the consumer back on.