Operation Manual

PerfectView LCD250 Safety and installation instructions

If you disconnect the negative terminal of the battery, all data stored in the volatile

memories will be lost.

z The following data must be set again, depending on the vehicle equipment options:

– Radio code

– Vehicle clock

–Timer

– On-board computer

– Seat position

You can find instructions for making these settings in the appropriate operating

instructions.

Observe the following installation instructions:

z Secure the monitor in such a way that it cannot become loose under any circumstances

(sudden braking, accidents) and cause injuries to the occupants of the vehicle.

z Do not attach the monitor in the air bag deployment path, as this could cause injury if

the airbags are triggered.

z To prevent damage, when drilling ensure that there is sufficient space on the other side

for the drill head to come out (fig. 2, page 4).

z Deburr all drill holes and treat them with a rust-protection agent.

Observe the following instructions when working with electrical parts:

z When testing the voltage in electrical cables, only use a diode test lamp

(fig. 1 1, page 3) or a voltmeter (see fig. 1 2, page 3).

Test lamps with an illuminant (fig. 1 3, page 3) consume voltages which are too high

and which can damage the vehicle’s electronic system.

z When making electrical connections, ensure that

– They are not kinked or twisted,

– They do not rub on edges,

– They are not laid in sharp edged ducts without protection (fig. 3, page 4).

z Insulate all connections.

z Secure the cables against mechanical wear with cable binders or insulating tape,

for example to existing cables.

_LCD250.book Seite 33 Mittwoch, 21. November 2007 3:01 15