Instructions / Assembly

iOnBoost™ V8 by Wagan Tech
®
10
www.wagan.com
12. When finished, disconnect the clamps in reverse sequence of connecting procedure—
first disconnect negative (black), then positive (red) clamps. Do not let the clamps touch
each other.
13. Disconnect the jumper cable assembly from the unit.
14. When convenient, using either AC or DC charging adapter, completely charge the
iOnBoost battery.
15. Store the unit and charge adapters in a cool, dry environment, away from flammable
materials. Remember to fully charge the unit every three months.
TROUBLESHOOTING
Jumpstart Warning Lights
The iOnBoost is ready to jumpstart when the cables are connected and a steady green light
illuminates on the cable safety block. The following chart displays the combinations of warning
lights that occur when the iOnBoost fails to display the ready light:
Warning lights Type of warning Solution
Flashing red
and green
lights
No vehicle battery detected
Cables are not making a
good connection
Vehicle battery voltage too
high for jumpstarting
Check cable connection.
Check terminals for corrosion.
Make sure the iOnBoost is fully charged.
Check with a mechanic for other starting
related issues.
Solid red and
green lights
30-second timer has
expired; the smart cable has
shut down
Disconnect cables from both the battery
and the iOnBoost and follow connection
procedure again.
Solid red light
(no green)
iOnBoost charge is too low
for jumpstarting
The iOnBoost needs to be recharged.
Flashing red
light with alarm
(no green)
Short-circuit or reverse
polarity
Over heating
Disconnect immediately and follow proper
connection procedure again.
Disconnect and allow unit to cool for 10
minutes.
Flashing red
and green with
alarm
Reverse charge Disconnect the iOnBoost from the vehicle
battery immediately.