Use and Care Manual

Solar + LED Floodlight 1000 by Wagan Tech
®
9
www.wagan.com
When the timer is over, it will reset to the default M1 motion detection mode and
repeat this program (Timer + M1) the following night, until another program is
selected.
To cancel the Timer mode, long press one of the T2, T3 or T4 buttons for 2
seconds. The indicator LED's on the light will flash 3 times.
Red LED indicators
MEMORY
The light will remember the last button/program pressed and revert to that setting
the following nights until a new program is set.
Examples:
If you choose 60% (no timer) the first night and do not change it, it will keep
60% the next night. But if the battery is low, it will default to M1.
If the light is set to 60% brightness for 4 hours on night 1, it will change to
M1 mode at the end of the 4 hours. On night 2, it will run the program for
60% brightness for 4 hours and then M1. This pattern will continue until
another button is pressed.
If the battery drains during timer mode, the light will turn off but will keep
the same lighting mode the next night once the battery is recharged.