User`s manual

www.wagan.com

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

• Keep the cables between the battery and the power inverter as short as

possible and twist them together with about 2 to 3 twists per foot. This

minimizes radiated interference from the cables.

• Ferrite beads may be installed around battery cables and AC appliance

cords to reduce noise.

MAINTENANCE

Very little maintenance is required to keep the inverter operating properly.

Periodically check to ensure all terminals and connectors are secure and tight.

HEAT DISPERSAL

The inverter generates heat while it is working. This is not a malfunction. However,

if the inverter gets too hot while working, it will turn off by itself. Position the inverter

where air ﬂows freely around it to allow the heat to disperse. The inverter’s thermal

protection prevents it from operating when its temperature exceeds 130ºF ± 10ºF

(55ºC ± 5ºC).

TROUBLESHOOTING

PROBLEM: Low or No Output Voltage – Fault LED Lit

Reason Solution

Poor contact with battery or inverter

terminals.

Clean terminals thoroughly. Reinstall

and tighten.

PROBLEM: Inverter Automatically Shut Down – Fault LED Lit

Reason Solution

Battery voltage below 10 Volts Charge or replace battery.

Inverter is too hot.

(Thermal protection mode.)

Allow inverter to cool.

Check for adequate ventilation.

Reduce the load on the inverter to

rated continuous power output.

Unit may be defective. See warranty and call customer service.