Product Manual

AIR COMPRESSOR OPERATION
Pull out hose from compar tment. Place quick connect
chuck over valve stem of tire with thumb lever in the
vertical position. Push down firmly and lock into place by
pressing thumb lever to horizontal position.
Turn compressor's switch on and monitor pressure using
the built-in prsssure gauge. DO NOT OVERINFLATE
PRODUCTS BEYOND THE MANUFACTURER'S
RECOMMENDATIONS.
When desired pressure is reached, turn off compressor and disconnect
hose.
NOTE: If tire is completely deflated, it is possible that the seal between the
tire and the rim could be broken allowing air to leak out when trying to
inflate. This usually happens only on completely flat tires. In the event this
situation occurs, you will have to jack up your car prior to inflating the tire.
For inflating other articles, select the appropriate adaptor and insert into
the hose nozzle as shown. Inflate as illustrated.
CAUTION: NEVER LEAVE COMPRESSOR UNATTENED WHILE IN USE.
Working Light:
The Quick Flow 3 In 1 Air Compressor comes with a built-in 12V 6W crypton light for a powerful and bright torch. Once the
Quick Flow 3 In 1 Air Compressor is connected to a 12V power outlet, just move the switch to the LIGHT position for a simple
use.
Emergency Light:
In case of need, you can use the exchangeable amber colored lens to use the blinking light as an emergency function. Just
move the switch to the EMERGENCY LIGHT position.
Changing the 12V 6W crypton Bulb:
Unscrew ring from front of light moving anti clockwise. Unscrew bulb and replace with a new one. Place ring and lens on the
unit by turning it clockwise.
Changing colored and clear lens:
Unscrew ring from front of light moving anti clockwise. Take lens from inside the ring holder and replace for the desired one.
Place ring and lens on the unit by turning it clockwise.
Specification:
Pressure Reader: 260 PSI GAUGE
Air Hose: 14"
12Volt Cord: 125"
Accessories: 3 Nozzles, collar, Inflator Nozzle, Sport Needle
Quick Flow 3 In 1 Air Compressor
NOTE: For athletic balls, moisten needle before inserting it into the ball
valve. For other pneumatic articles, the nozzle should be inserted into
valve and held tightly to insure a good seal.
Users' Manual
Figure1 Figure2
ITEM# 2014