User`s manual

User’s Manual—Please read before using this equipment
©2009 Wagan Corporation. All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
HEAT DISPERSAL
The inverter generates heat while it is working. This is not a malfunction.
However, if the inverter gets too hot while working it will turn off by itself.
Position the inverter where air flows freely around it to allow the heat to
disperse. The inverter’s thermal protection prevents it from operating when its
temperature exceeds 130ºF ± 10º (55ºC ± 5º).
TROUBLESHOOTING
Condition Solution
Poor contact Clean contact parts thoroughly
Battery voltage is too low Start the engine to recharge the
battery. Replace the battery if
needed.
Shutdown on overload Reduce the inverter’s wattage load
Thermal shutdown Allow the inverter to cool down by
reducing the load or turning it off for
a while.
Receptacle has no power Check the receptacle wiring.