R Item no.
User’s Manual—Please read before using this equipment FRONT features & functions charging jack LeD Work light charging indicator Volt Meter Light switch On/Off safety switch Dc socket On/Off switch UsB On/Off UsB Outlet 12V Dc socket 12V Dc socket Battery check button air hose Heavy duty booster clamps ©2009 Wagan Corporation. All Rights Reserved. Wagan and wagan.com are trademarks used by Wagan Corporation.
500 Peak Amp Jumpstarter with Air Compressor by Wagan Tech BACK features & functions air compressor On/Off switch air compressor gauge 260Psi air compressor shock-absorbing rubber base R
User’s Manual—Please read before using this equipment Thank you for purchasing 500 Peak Amp Jumpstarter with Air Compressor by Wagan Tech. With normal care and proper treatment it will provide years of reliable service. Please read all operating instructions carefully before use.
500 Peak Amp Jumpstarter with Air Compressor by Wagan Tech • Do not operate this device while wearing vinyl clothing. Static electricity may be generated when vinyl clothing is rubbed. • This product is not intended for use in the rain or temperatures above 130°F. • Use only the provided chargers, cables and clamps. Unauthorized parts may damage the unit. • The product must be properly assembled in accordance with the assembly instructions before it is used.
User’s Manual—Please read before using this equipment • Do not charge the unit on a boat, boat ramp or dock since the electrical cords and outlets used for charging could cause severe electrical shock if they get wet. • It is recommended that the unit be in an upright position while charging. • Make sure both cable clamps (positive and negative) are placed in their storage holsters when not in use. CHARGING WITH THE 110V AC CHARGER: . Insert the AC charger plug into charging jack of the unit. 2.
500 Peak Amp Jumpstarter with Air Compressor by Wagan Tech JumpstartING A VEHICLE WARNING: Vehicles equipped with onboard computers may be affected if the engine battery is jumpstarted. Read your vehicle owner’s manual before attempting to start the vehicle to determine if external starting assistance can be used. Failure to follow these instructions may cause damage or even an explosion. Use safety glasses to protect eyes while jumpstarting a battery. .
User’s Manual—Please read before using this equipment • Follow instructions for a negative grounded system as indicated below: a. Securely connect the positive (+) red clamp to the positive (POS, P, +) terminal of the vehicle battery or the remote positive (+) terminal if equipped. b. Securely connect the negative (-) black clamp to the vehicle chassis, engine block or a non-moving metal part of the vehicle which is verified to be grounded.
500 Peak Amp Jumpstarter with Air Compressor by Wagan Tech until the other problem is determined and corrected. 0. Standing as far away from the vehicle battery as is practical, disconnect the clamps in reverse sequence to the connection procedure: • For negative grounded systems, first disconnect negative (black) then positive (red) clamps. • For positive grounded systems, first disconnect positive (red) then negative (black) clamps.
User’s Manual—Please read before using this equipment . When the desired pressure is reached, turn off compressor and turn the locking thumb lever to the UP position. Remove the stem connector from valve stem. Also remove the valve stem adapter if applicable. 8. Replace the cap on the air valve stem. Inflating plastic inflatables (balls, air mattresses, rubber rafts, etc.) Check manufacturer’s specifications on items to be inflated for correct inflation pressure. . Remove the cap from the air valve stem.
500 Peak Amp Jumpstarter with Air Compressor by Wagan Tech . Uncover the dust cover from the Power Port. 2. Insert the 12V DC accessory plug into the Power Port. . Set the On/Off safety switch to the “ON” position. 4. Set the power port On/Off switch to the “ON” position by pressing down the section of the switch marked “I”. 5. Operate the appliance as usual. . After use, set the power port On/Off switch to the “OFF” position by pressing down the section of the switch marked “O”. .
User’s Manual—Please read before using this equipment SPECIFICATIONS Power Supply Battery 14AH sealed lead acid Power Supply DC Output: 12 volts nominal Air Compressor 260 PSI Power Supply Charging Time (First Time Charging using AC Charger) 38 hours Power Supply Charging Time (recharging with AC charger) 34 hours Power Supply Charging Time (recharging with 12 volt DC charger) 14 hours Storage Store in a cool dry area. ©2009 Wagan Corporation. All Rights Reserved. Wagan and wagan.
WAGAN Corp. Limited Warranty Warranty Duration: This product is warranted to the original purchaser for a period of one (1) Year from the original purchase date, to be free of defects in material and workmanship. WAGAN Corporation disclaims any liability for consequential damages. In no event will WAGAN Corporation be responsible for any amount of damages beyond the amount paid for the product at retail.
All WAGAN Corporation Products must be registered within (30) days of purchase to activate this warranty. Mail the complete registration form, along with a copy of the original sales receipt to: Signature Date of purchase Store name Item purchased E-mail address State, Zip code City Mailing address Name Attn: Customer Service WAGAN Corporation 31088 San Clemente St. Hayward, CA 94544 Please activate my limited warranty for WAGAN Corp. Date Item no.
R www.wagan.com ©2009 Wagan Corporation. All Rights Reserved. Wagan and wagan.com are trademarks used by Wagan Corporation.
