Item #2601 User’s Manual
Elite™ 400W Pro Pure Sine Inverter by Wagan Tech® User’s Manual—Read before using this equipment INTRODUCTION Thank you for purchasing this Wagan Tech® Elite™ 400W PRO Pure Sine Wave DC to AC Power Inverter. The Elite PRO™ represents numerous improvements to our standard pure sine that meet the needs of more demanding environments—delivering clean quality power at an affordable price. It delivers a true sine wave AC identical to that of commercial power.
Elite™ 400W Pro Pure Sine Inverter by Wagan Tech® User’s Manual—Read before using this equipment • USB Power Port — This power port can supply 5 volts at 2.1A for charging or powering smartphones, tablets and e-readers, MP3 players, GPS and other small electronic devices. FRONT PANEL Power LED Fault LED On/Off Switch AC Outlet • Audible Alarm (internal to the inverter) — When the Audible Alarm makes a buzzing sound, the inverter senses a low battery condition.
Elite™ 400W Pro Pure Sine Inverter by Wagan Tech® LOAD CONSIDERATIONS The startup load of an appliance is a major factor of whether this inverter can power it. This initial load is only momentary. With many appliances, it is approximately twice the continuous load, but some appliance startup loads can be as high as eight times the continuous load. To determine if an appliance or tool will operate with this inverter, first run a test.
Elite™ 400W Pro Pure Sine Inverter by Wagan Tech® User’s Manual—Read before using this equipment 5. Place the ON/OFF power switch in the “ON” position. The green LED should turn on, indicating the inverter is powered and operating normally. 6. Place the ON/OFF power switch in the “ON” position. The green LED should turn on, indicating the inverter is powered and operating normally. 6. When the inverter is not in use, place the inverter’s ON/OFF Power Switch to the “OFF” position.
Elite™ 400W Pro Pure Sine Inverter by Wagan Tech® TROUBLESHOOTING User’s Manual—Read before using this equipment PROBLEM: Inverter Shut Down – Fault LED Lit PROBLEM: Low or No Output Voltage – Fault LED Lit Reason Solution Poor contact with battery, inverter terminals, or DC socket. Clean terminals thoroughly. Reinstall and tighten. Clean DC socket with nonmetallic abrasive emery stick. PROBLEM: No Output Voltage – No LEDs Lit Reason Solution Blown fuse. Check vehicle’s Accessory Socket Fuse.
Elite™ 400W Pro Pure Sine Inverter by Wagan Tech® SPECIFICATIONS* • Output Waveform: Pure Sine Waveform • Input: 10V–15V DC • Output: 120V AC • TrueRated™ Power: 400 watts • Peak Surge: 800 watts • Efficiency: > 90% • Frequency: 60Hz • Total Harmonic Distortion (THD): < 3% • No load current draw: < 0.4A • Battery low alarm: 10.5V ± 0.5V DC • Battery low shutdown: 9.5V ± 0.5V DC • Over voltage shutdown: 15.0V–15.
WAGAN Corp. Limited Warranty The WAGAN Corp warranty is limited to products sold only in the United States. All Wagan Tech products must be registered within (30) days of purchase to activate its warranty. To register your product, please visit http://tinyurl.com/waganwarranty. Be sure to keep the original receipt as it will be required when returning a product under the warranty.
31088 San Clemente Street Hayward, CA 94544, U.S.A. U.S. & Canada Toll Free: 1.800.231.5806 Tel: +1.510.471.9221 customerservice@wagan.com www.wagan.com ©2012 Wagan Corporation. All Rights Reserved Wagan Tech and wagan.
