User`s manual

Elite

™

1000W PRO by Wagan Tech

www.wagan.com

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

Remote On/OFF Switch

This inverter is supplied with a 100-foot range, battery-powered, wireless remote

ON/OFF feature. To enable the Remote Switch, the front panel On/Off Switch of

the inverter must be in the “on” position.

To turn on the inverter, momentarily press “unlock” button. To turn the inverter off,

momentarily press “lock” button. If the wireless remote fails to control operation

of the inverter, you may be out of range for the radio signal—move closer to the

inverter. If the remote switch has a depleted battery, open the unit by unscrewing

the three small screws on the back side of the remote control and replace the 12

volt, 23A alkaline battery with a new one.

Retracted Antenna

Retractable Antenna

Extended Antenna

On Switch

Off Switch

Sliding Cap

Rear Panel

• Positive Terminal (red): Positive DC Input

• Negative Terminal (black): Negative DC Input

• DC Connector Guard: Protects your DC cables from accidentally touching.

• Ground Terminal: Grounding the inverter enclosure ensures personnel safety

should a DC cable problem occur. During the installation procedure, the

Ground Terminal is connected either to a vehicle chassis or to the Negative DC

Terminal of the battery. Do not directly connect this ground connection to the

negative DC terminal of the inverter. Use an insulated 10 gauge wire to make

the ground connection. If the inverter installation is located in ﬁxed location,

the safety wire can be connected to earth’s ground.

• Cooling Fans: High-speed and temperature controlled

Positive Terminal (Red)

Negative Terminal (Black)

DC Connector Guard

Cooling Fan