User`s manual

ManualsBrandsWagan Manualselectrical equipment & suppliesElite 1000W PRO

Elite

™

1000W PRO by Wagan Tech

www.wagan.com

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

OPERATING ISSUES

(Television and Audio Equipment Suggestions.)

Although all inverters are shielded and ﬁltered to minimize signal interference, some

interference with your television picture may be unavoidable, especially with weak

signals. However, here are some suggestions that may improve reception.

• Make sure that the television antenna produces a clear signal under normal

operating conditions (i.e. at home plugged into a standard 115V AC wall

outlet). Also ensure that the antenna cable is properly shielded and of good

quality.

• Sometimes vehicle alternators produce some electrical noise. There are ﬁlters

available to mount on the alternator to reduce noise.

• Change the positions of the inverter, antenna cables, and television

power cord.

• Isolate the television, its power cord and antenna cables from the 12 volt

power source by running an extension cord from the inverter to the television

set.

TROUBLESHOOTING

PROBLEM: Low or No Output Voltage – Fault LED Lit

Reason Solution

Poor contact with battery or inverter terminals. Clean terminals thoroughly. Reinstall and tighten.

PROBLEM: Inverter is Shut Down – Fault LED Lit

Reason Solution

Battery voltage below 10.4 Volts Charge or replace battery.

Inverter is too hot (thermal shut down mode). Allow inverter to cool.

Check for adequate ventilation.

Reduce the load on the inverter to rated continuous

power output.

Unit may be defective. See warranty and call customer service.

PROBLEM: Inverter Shut Down – Fault LED Lit – Display shows overload

Reason Solution

Equipment being operated draws too much power. Use a higher capacity inverter or do not use this

equipment.

PROBLEM: Continuous Buzzing Sound – Display Shows Low Voltage

Reason Solution

Input voltage below 11 Volts Keep input voltage above 11 Volts

Poor or weak battery condition. Recharge or replace battery.

Poor or loose cable connection Inspect terminals and tighten all connections.

Inadequate power being delivered to the

inverter or excessive voltage drop.

Use heavier gauge DC cable.

Keep cable length as short as possible.

DISPOSAL/RECYCLING OF INVERTER

Electronic products are known to contain materials that are toxic if improperly

disposed. Contact local authorities for disposal and recycling information.