User`s manual

Elite

™

1000W Pro by Wagan Tech

www.wagan.com

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

• Make sure that the television antenna produces a clear signal under normal operating condi-

tions (i.e. at home plugged into a standard 110V/120V AC wall outlet). Also ensure that the

antenna cable is properly shielded and of good quality.

• Sometimes vehicle alternators produce some electrical noise. There are ﬁlters available to

mount on the alternator to reduce noise.

• Change the positions of the inverter, antenna cables and television

power cord.

• Isolate the television, its power cord and antenna cables from the 24 volt power source by

running an extension cord from the inverter to the television set.

TROUBLESHOOTING

PROBLEM: Low or No Output Voltage – Fault LED Lit

Reason Solution

Poor contact with battery or inverter terminals. Clean terminals thoroughly. Reinstall and tighten.

PROBLEM: Inverter is Shut Down – Fault LED Lit

Reason Solution

Battery voltage below 19 Volts Charge or replace battery.

Inverter is too hot (thermal shut down mode). Allow inverter to cool.

Check for adequate ventilation.

Reduce the load on the inverter to rated continuous

power output.

Unit may be defective. See warranty and call customer service.

PROBLEM: Inverter Shut Down – Fault LED Lit – OVL Display

Reason Solution

Equipment being operated draws too much power. Use a higher capacity inverter or do not use this

equipment.

PROBLEM: Continuous Buzzing Sound – Display Shows Low Voltage

Reason Solution

Input voltage below 21 Volts Keep input voltage above 21 Volts

Poor or weak battery condition. Recharge or replace battery.

Poor or loose cable connection Inspect terminals and tighten all connections.

Inadequate power being delivered to the inverter

or excessive voltage drop.

Use heavier gauge DC cable.

Keep cable length as short as possible.