Item No.
Elite™ 200W PRO by Wagan Tech® Thank you for purchasing the Wagan Tech® Elite™ 200W PRO Pure Sine Wave DC to AC Power Inverter. Elite™ 200W PRO represents numerous improvements to our standard pure sine that meet the needs of more demanding environments— delivering clean quality power at an affordable price. It delivers a true sine wave AC identical to that of commercial power. Use this inverter to power AC appliances in your vehicle or off-grid backup power systems.
User’s Manual—Read before using this equipment Specifications* Output waveform Pure sine wave Input 12V DC Output 120V AC TrueRated Power™ 200 watts Peak surge 400 watts Efficiency > 90% Frequency 60Hz Total harmonic distortion (THD) < 3% No load current draw < 0.4A Battery low alarm 10.5V ± 0.5V DC Battery low shutdown 9.5V ± 0.5V DC Over voltage shutdown 15.5V ± 0.5V DC Cooling fan Thermally controlled AC output sockets 2 USB power port 2.1A, 5V ± 0.
Elite™ 200W PRO by Wagan Tech® Warning INVERTER OUTPUT CAN BE LETHAL. IMPROPER USE OF THIS INVERTER MAY RESULT IN PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. 3 • Keep the inverter away from any direct heat source or combustible materials. • Keep well ventilated—this device generates heat. • Keep this inverter in a dry environment. • Do not operate any equipment over 200 watts. • This inverter is designed to operate from a 12 volt DC power source only.
User’s Manual—Read before using this equipment Front Panel Power LED Fault LED AC Outlet On/Off Switch AC Outlet USB Power Port • ON/OFF Switch — This switch controls AC output of the inverter. • Operating LED (Green) — When this green LED is lit, the inverter is operating normally. • FAULT LED (Red) — The RED indicator turns on as the inverter shuts down due to overheating, overload, under voltage, or over voltage. • Immediately turn off all AC appliances if the FAULT LED is lit.
Elite™ 200W PRO by Wagan Tech® • Audible Alarm (internal to the inverter) — When the Audible Alarm makes a buzzing sound, the inverter senses a low battery condition. The user should reduce the AC load, charge the battery, and check the DC cable for excessive losses.
User’s Manual—Read before using this equipment To determine if an appliance or tool will operate with this inverter, first run a test. The inverter will automatically shut down in the event of an output overload so there is no danger of damaging either the inverter or the equipment. When the red LED indicator is lit, the inverter is signaling a fault. Maximum Power from Vehicular Accessory Sockets Most vehicular accessory sockets that are controlled through a vehicle’s ignition switch are fused at 15 amps.
Elite™ 200W PRO by Wagan Tech® immediate overload shut down and or blow a fuse. The fuse on this inverter is external and replaceable for this purpose. Connecting the Inverter DC Plug Adapter Cord 1. Connect the red (+) and black (−) terminals of the supplied DC Plug Adapter Cord to the red (+) and black (−) terminals on the rear of the inverter. • Be sure to connect them into the correct polarity terminals on the rear of the inverter.
User’s Manual—Read before using this equipment • Make sure that the television antenna produces a clear signal under normal operating conditions (i.e. plugged into a standard 110V/120V AC wall outlet). Also ensure that the antenna cable is of good quality and properly shielded. • Sometimes vehicle alternators produce some electrical noise. There are filters available to mount on the alternator to reduce the noise. • Change the positions of the inverter, antenna cables, and television power cord.
Elite™ 200W PRO by Wagan Tech® PROBLEM: Inverter Auto Shut Down – Fault LED Lit Reason Solution Battery voltage is below 9.5 volts. Charge or replace battery. Inverter is too hot (thermal shut down mode). Allow inverter to cool. Check for adequate ventilation. Reduce the load on the inverter to the specified TrueRated™ power max output. PROBLEM: Inverter Shut Down – Fault LED Lit Reason Solution Equipment being operated draws too much power.
WAGAN Corp. Limited Warranty The WAGAN Corp. warranty is limited to products sold only in the United States. All Wagan Tech products must be registered within (30) days of purchase to activate its warranty. To register your product, please visit http://tinyurl.com/waganwarranty. Be sure to keep the original receipt as it will be required when returning a product under the warranty.
31088 San Clemente Street Hayward, CA 94544, U.S.A. Tel: + 1.510.471.9221 U.S. & Canada Toll Free: 1.800.231.5806 customerservice@wagan.com www.wagan.com ©2013 Wagan Corporation. All Rights Reserved Wagan Tech and wagan.
