User`s manual

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

• Make sure that the television antenna produces a clear signal under normal

operating conditions (i.e. plugged into a standard 110V/120V AC wall

outlet). Also ensure that the antenna cable is of good quality and properly

shielded.

• Sometimes vehicle alternators produce some electrical noise. There are

ﬁlters available to mount on the alternator to reduce the noise.

• Change the positions of the inverter, antenna cables, and television power

cord.

• Isolate the television, its power cord, and antenna cables from the 12

volt power source by running an extension cord from the inverter to the

television.

TROUBLESHOOTING

PROBLEM: Low or No Output Voltage – Fault LED Lit

Reason Solution

Poor contact with battery, inverter

terminals, or DC socket.

Clean terminals thoroughly. Reinstall

and tighten. Clean DC socket with non-

metallic abrasive emery stick.

PROBLEM: No Output Voltage – No LEDs Lit

Reason Solution

Blown fuse. Check vehicle’s Accessory Socket Fuse.

If the fuse is blown, replace with the

same type and rating fuse.