User`s manual

PWR/BAND
CH +
Audio Input
Memory
VOL +
LED screen
www.wagan.com
Power Dome™ NX by Wagan Tech
8
© 2010 Wagan Corporation.
All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Please read before using this equipment.
9
TURNING ON AND TUNING THE RADIO
1. Carefully raise and extend the antenna.
2. Press and hold the PWR/BAND button for at least 1 second to turn the radio on.
The current frequency is displayed, with the AM/FM band shown in the corner.
3. Tap the PWR/BAND button quickly to switch between AM and FM bands.
4. Tap the CH + and CH − buttons to adjust the station. Press and hold the buttons to
automatically scan stations.
5. Tap the MEMORY button to switch to your station preset. Continue pressing the
button to cycle through each preset. See the section on setting radio station presets
on the next page.
6. When finished, press and hold the PWR/BAND button for at least 1 second to turn
off the radio and return to Clock Mode. Carefully retract the antenna and return it
to the lowered position.
ADJUSTING THE VOLUME
1. With the radio turned on, Tap the VOL + and VOL − buttons to adjust the volume.
Press and hold the buttons to adjust the volume quickly. The radio can be adjusted
by 32 levels.
2. When using an external audio device in the Audio Input Jack, the volume will be
controlled by the external device.
SETTING THE CLOCK
1. With the radio off and the Display showing in Clock Mode, press and hold the
MEMORY button for at least 1 second.
2. The clock display will flash and enter Clock Set Mode.
3. Tap the CH + button to increase the hour. Hold the button continuously to increase
the adjustment speed. The display will switch from AM to PM and PM to AM
appropriately.
4. Tap the CH − button to increase the minutes. Hold the button continuously to
increase the adjustment speed.
5. Tap the MEMORY button again to confirm the new clock time, returning to regular
Clock Mode.
SETTING RADIO STATION PRESETS
1. While the radio is playing, press and hold the MEMORY button for at least 1
second to record the current station as a preset.
2. When the “M” on screen flashes, tap the MEMORY button repeatedly to select the
desired memory position between 1–10.
3. Press and hold the MEMORY button once more to confirm the station preset at that
position. The radio will switch back to regular Radio Mode.
4. Repeat steps 1 to 3 for each desired preset.
5. When using the radio, tap the MEMORY button to select a preset. The current
preset is displayed on screen with the “M” and the preset number 1–10.
6. The radio can hold up to 10 AM or 10 FM station presets in memory. If presets are
stored for AM, then the FM presets will be lost. The same applies for FM presets
replacing AM ones.
3.5MM AUDIO INPUT
1. Turn the radio on.
2. Insert a 3.5mm audio cable into the audio input jack.
3. The opposite end of the cable should be plugged into a compatible audio device.
4. Turn on the audio device and set it to output sound. The sound should be audible
from the Power Dome speakers.
5. The Power Dome’s USB Power Port can conveniently power your audio device.