User`s manual

ON
OFF
Connect Red, Positive (+) Clamp
to Positive Battery Terminal
to vehicle chassis or non-moving,
metal vehicle component
Voltmeter
(Measures Power
Dome Battery)
Switch Jumper Safety Switch On
1
2
3
Switch to Blinker Mode
Attach Hazard Flasher Lens to Light
www.wagan.com
Power Dome™ NX by Wagan Tech
12
© 2010 Wagan Corporation.
All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Please read before using this equipment.
13
WORK LIGHT
The Work Light is a cluster of bright LEDs located at the front of the Power Dome. The
location of the Work Light allows the light to be used while the Power Dome is being carried.
• Turn the Light Switch (located below the Pressure Gauge and Voltmeter) to the Work
Light “|” position.
• The light will illuminate.
• Turn OFF while not in use.
USING THE HAZARD FLASHER
The Hazard Flasher Lens turns the Power Dome light into a caution warning for passing
traffic.
1. Attach the red Hazard Flasher Lens Cover over the light snugly.
2. Switch the light on to Blinking mode by selecting “||” on the Light Switch.
3. Place the Power Dome in a spot easily noticed by other vehicles.