Item No.
ON/OFF switch Assembling bolt Nut PIR Washer Solar panel Light panel Bracket Features: 1. Smart Remote Control Function to satisfy different customer use. 3 main lighting mode as below a). Constant brightness all the time (100%/60%/30%/10%) b.) Dim lighting + motion sensor (30 seconds 100% High brightness) c.) Timer lighting mode (8 Option) 2. ALS (Adaptive Lighting System) to achieve all night lighting when Weather change. Constant current output! 3.
Specifications Solar Panel 14V, 22.7W LED 80 LED's, 4,500 lumens Charging Time 9-10 hours Lighting Mode 1. Constant brightness all the time (100%/60%/30%/10%) 2. Dim lighting + Motion Sensor (30 sec 100% High brightness) 3.
Operating Instructions: 1 How to unlock the working system? The internal battery is locked from factory for safety shipment, so users have to use supplied key pin to click the "on/off" socket and unlock the battery and lighting system. Remark: Then use the supplied pin key to click the "ON/OFF" hole, the red indicator turns on means the lamp is unlocked and you can use the remote controller; if no red indicator, means the lamp is locked or no power.
Working process instructions Use the supplied key pin to click the "ON/OFF" socket to unlock the battery Please fasten the light to the pole by the bolt Step 1: Light switch off for sun charging in daytime Step 2: When the first time use, at night, press the button "on" by remote controller to turn on the lamp, it will be the default lighting mode (M1)---10% dim light when no people around + PIR sensor 100% brightness for 30 seconds, then turn to dim light again.
Remote controller Indicator light Infrared transmitter Brightness key On key Timer key M1/M2 PIR mode key Off key ON: Turn on the lamp, when you first time turn on the lamp, the initial default lighting mode is M1. OFF: Turn off the lamp and save the last lighting mode.
Button 10%: To set brightness 10% for all the time till dawn, if you press any buttons of T1~T4, the lamp will turn on M1 lighting mode after timer end. Button 30%: To set brightness 30% for all the time till dawn, if you press any buttons of T1~T4, the lamp will turn on M1 lighting mode after timer end. Button 60%: To set brightness 60% for all the time till dawn, if you press any buttons of T1~T4, the lamp will turn on M1 lighting mode after timer end.
If you want to set up time to 5-6-7-8 hours, please pull the backside button to "ON" position.
Replace the inside battery work as the picture when the battery span life is in the end. Special note: 1.) Please notice to unlock the battery and working system by supplied Key Pin before install. 2.) Please give bright sunlight charging over 5 hours before first time use, as the battery is very low from factory. 3.
Warning: 1. Keep the device away from fire and oil in order to avoid any fire or explosion. 2. Any severe shock or smash to the light is not recommended. 3. No one except professional technicians should attempt to disassemble the light in order to avoid damaging the light. Package includes: 1. Key pin: 1pc 2. Assembling bolt: 4pcs 3. Nut: 4pcs 4.
