User Manual

CLEANUP (continued)

(a)

(b)

2b 3a 4

(c)

(d)

(e)

NOZZLE SEAL CONTROL FINISH NOZZLE ONLY

The nozzle seal may become stuck

inside the Control Finish nozzle

when the nozzle is removed. If

this occurs, make sure to pull it

out.

It is important that the nozzle seal

inside the nozzle be re-installed

properly. Make sure the cup

side of the seal (the side with the

groove) is facing out towards the

front of the nozzle. Improper

installation will cause leakage and

damage to the turbine.

Groove

CLEANING THE NOZZLE

1. Make sure power cord is unplugged. Remove the air hose from the turbine.

2. iSpray nozzle only -

a. Remove the adjustment ring (a) carefully from the connecting nut (b). Loosen

the connecting nut.

b. Remove the parts as shown. Clean all parts with a cleaning brush and the

appropriate cleaning solution.

To reassemble, see the instructions on the next page.

3. Control Finish nozzle only -

a. Unscrew the nut and remove the air cap and nozzle.

Remove the parts as shown*. Clean all parts with a cleaning brush and the

appropriate cleaning solution.

Reassemble all parts when clean**.

4. Clean the air vent (c) on the suction tube with a soft bristled cleaning brush.

5. Push the tab below the trigger, twist and separate the nozzle from the

handle.

Clean the rear of the nozzle (b) with the appropriate cleaning solution. Use a

thin layer of petroleum jelly to lubricate the O-ring (c).

6. Reattach the handle to the nozzle.