User Manual

14
EN
REASSEMBLY
1
(a)
(c)
1
(b)
2
2
3
1
(d)
(e)
3
4
3
(g)
(f)
4
TO REASSEMBLE
1. Insert the nozzle (1). Make sure to align the groove (a) and notch (b) and
align the nozzle opening with the needle.
i
Make sure the red nozzle seal is in place. Replace if it falls out and
is undamaged. Make sure the cup side of the seal (the side with the
groove) is facing out (c).
2. Put the air screen (d) in the air cap (e). Put both (2) on the nozzle (1) and
secure with the connecting nut (3).
i
This step is easier if the iSpray nozzle is facing up.
3. Snap the adjustment ring (4) into the connecting nut (3), enabling the
adjustment lever (f) on the peg (g) to be positioned in the air cap.
i
Make sure that the two recesses on the adjustment ring are
engaged in the air cap tabs.
4. Reassemble the spray gun.
i
Make sure the air valve tube is free of paint. If not, clean the air
valve tube by following the instructions on the next page. If clean,
make sure it is attached securely at both ends (see inset).
Groove