User Manual

MAINTENANCE

CLEANING THE FILTER

IMPORTANT: Before every use, you should inspect the air lter in the

turbine to see if it is excessively dirty. If it is dirty, follow these steps

to replace it.

IMPORTANT: Never operate your unit without the air lter. Dirt

could be sucked in and interfere with the function of the unit.

1. Open up the Power Box cover. Press the tab and remove the lter

cover.

2. Remove the dirty lter from the turbine and replace. The smooth

side of the air lter must be placed toward the turbine.

Secure the cover back onto the turbine.

CLEANING THE AIR VALVE TUBE

If paint has entered the air tube, proceed as follows.

1. Pull the air tube (a) at the top from the nozzle. Screw o the valve

cover (b).

Remove the valve seal (c). Clean all the parts carefully. Make sure to

remove any material from valve seal housing area (d).

IMPORTANT: The air tube and valve seal (c) are only solvent-resistant

to a limited extent. Do not immerse in solvent, only wipe.

2. Place the valve seal (c) in the valve cover (b) with the pin facing into

the tube.

Installing the valve seal into the valve cover will be much

easier if the valve cover is inverted.

3. Turn the nozzle upside down and screw on the valve cover (with

valve seal inside) from underneath.

Turning the nozzle upside down will prevent the valve seal

from falling out of the valve cover during reinstallation.

4. Place the air tube on the valve cover and on the nipple at the nozzle.

(a)

(b)

(c)

(d)

(c)

(b)