User Manual
4
EN
OVERVIEW
1
2
(b)
(a)
(c)
3
4
i
In order to set up the system, items will need to be retrieved from inside of the X-Boost Power Box.
1. Lower the carry handle by pressing the locking tabs on either side
of the handle.
2. Open the Power Box (a). Open the air hose retainer (b) inside the
cover and retrieve the air hose and handle assembly (c). Close the
air hose retainer.
3. Unwrap the power cord. Slide the power cord into the provided
recess.
IMPORTANT: Do not close the Power Box cover if the power
cord is not positioned correctly. The power cord could be
damaged.
4. Remove the desired spray nozzle from inside the Power Box*. Close
the cover and pull the carry handle upwards. This will make the
nozzle holder accessible during usage.
*NOZZLE SELECTION
i
Your unit includes two spray nozzles. See below to determine
the correct nozzle for your spraying project.
CONTROL FINISH NOZZLE
Used for small projects and ne nishing.
Designed for spraying thinner materials, such as
water- and oil-based stains and thinned paints.
The Control Finish Nozzle leaves a smooth nish.
iSPRAY NOZZLE
Used for broad surface coating. Designed for
spraying thicker materials, such as latex paints
and stains. Spraying with this nozzle will leave a
slightly coarser nish that is between a roller and
ne-nish sprayer.
i
These two spray nozzles have dierent spray pattern / width
controls. Make sure to familiarize yourself with the controls on
each spray nozzle. See the “Controls” section, page 8-9.