User Manual

MATERIAL PREPARATION

Material to be sprayed may need to be strained to remove any impurities in the paint which may enter and clog the system.

Impurities in the paint will give poor performance and a poor nish.

Only thin the material if absolutely necessary to improve spray performance. Optimal spray performance should be

acheived simply by adjusting the various controls on the unit.

TO PREPARE THE MATERIAL

1. Stir the spraying material thoroughly.

2. Unscrew the cup from the nozzle.

3. After the material has been properly thinned* and strained, ll the

container to desired level.

*THINNING THE MATERIAL

For certain spraying situations or desired nishes, thinning the material

may be desired. It is not necessary for most materials when used with

the iSpray nozzle. For use with the Control Finish nozzle thinning may

be needed to acheive a ner nish. Make sure you adjust the X-Boost™

and Material Flow settings for your specic material needs.

If thinning is necessary, use the proper solvent as specied by the

material manufacturer. Never exceed the thinning advice given by the

coating manufacturer.

Do not thin with materials that have a flashpoint

below 100°F (38°C). The material flashpoint

should be shown on the material container.